Wireless Alarm Panels
LS5000 Panel
LY52-021-38
The LS5000 is an advanced radio security alarm system which is both easy to install and operate. The alarm control panel can be installed as a wireless unit, a wired or two wired panel or mixed of all three.
The system can control up to 24 detectors, 16 of which can be wireless, 4 traditional detectors (6 wire PIR or door/window contacts) and 4 two wire detectors (2 wire PIR).
Every component contains a tamper detection device. If any attempt is made to interfere with any part of the installation, an alarm will sound immediately even if the system is not armed.
The system incorporates sophisticated anti-jamming protection for added protection.
Arming/Disarming
| On board keypad |
| Wireless key fob |
Engineer Programmable Functions
| Select walk-through zones |
| Select entry/exit zones |
| Full alarm for tamper in standby mode |
| Remote dis requires entry timer |
| Enable/disable secondary pin code |
| Engineer only reset |
User Programmable Functions
| Wireless detector |
| Delete a wireless detector |
| Entry/exit time: 10-60 seconds |
| Siren duration:1-20 minutes |
| Siren test |
| Strobe test |
| Chime zone |
| New user pin code |
| New secondary pin code |
| Recall alarm events maximum 10 events |
Walk Test
| Visual on all zones |
Panel LED Indicators
| Mains, interference, fault, low battery, tamper, intruder |
Wired Terminal Connections
| 4 X 6 wire zones |
| 4 X 2 wire zones |
| 1 x tamper |
| 1 x external strobe/siren |
| 1 x AC in |
| 1 X 50 meters flat twin core wire |
| 1 X External mains adaptor |
| 1 x battery backup |
| 1 x aux |
Electrical Specification
| Current consumption | quiescent: 240mA, In alarm: 420mA |
| Auxiliary voltage output | 12Vdc |
| Siren/strobe voltage output | 12Vdc |
| Battery charge voltage | 13.8Vdc |
| Fuses | strobe, bell, aux, AC |
| Radio system | 433Mhz super heterodyne type narrow band receiver |
Power Supply Adaptor Specification
| Primary mains supply | 230Vac, 50Hz |
| Secondary | 16Vac |
| Mains Fuse | 3 amp 250V |
| Battery back up | 1.3 - 2.2Ah 12vdc sealed lead acid battery |
Environmental Specification
| Operating Temperature | -0ºC - + 40ºC |
| Storage temperature | -20ºC - + 60ºC |
| Maximum humidity | 95% non-condensing |
Physical Specification
| Dimensions | 214mm X 286mm X 50mm |
| Housing material | Polycarbonate |
European Standards
| Conforms to European law (EU) Low Voltage Directives LVD 73/23/EEC (amended 93/68/EEC) and Electro-magnetic Compatibility (EMC) 89/336/EEC (Amended by 92/31/EEC and 93/68EEC) RoHS |
Downloads
 |
Data Sheet |
|
Instructions |